Baslinux mailing list

[Ron Clarke <ariadne AT earthlink.com.au>]

Hi Sindi,

On Tue, 11 May 2004 23:31:56 -0400 (EDT)
Sindi Keesan <keesan AT iamjlamb.com> wrote:

> 
> On Wed, 12 May 2004, Ron Clarke wrote:
> 
> > Hi Sindi,
> > 
> > On Tue, 11 May 2004 17:31:36 -0400 (EDT)
> > Sindi Keesan <keesan AT iamjlamb.com> wrote:
> > 
> > > Is there some
> > > way to use network cards in DOS?  We have been using llpro to transfer 
> > > BL2
> > > ramdisk and then BL2 to transfer the hard drive BL2.
> > 
> 
> >     If you can get the cards setup properly in DOS, then llpro can use
> > that connection too.
> 
> > 
> > Regards,
> >         Ron 
> > 
> 
> Can you explain how to set up ethernet cards in DOS?  

    No.    :(

    I also downloaded all the correct software and tried to "install" or 
"configure"
the cards I have (in DOS), but failed.

     That is why I have been paying so much attention to doing the same in 
BL2.1

Regards,
         Ron
  
-- 
Ron Clarke 
AUSREG Consultancy      http://www.valylink.net.au/~ausreg/index.html
Tadpole Tunes           http://tadpole.mytunebook.de/
This mail sent to you from sylpheed running on penguin-power