Baslinux mailing list

[Hal MacArgle <halinux AT kvinet.com>]

On 05-12, Sindi Keesan wrote:

> Is it possible instead to just write and use a script to load the modules 
> with the correct address and irq?  I tried this with plip and could not 
> get the script to work, though typing the five lines manually worked.

        With the proper commands try "sleep" in between lines to give
one command a chance to work before invoking the other.. Start out
with, what, sleep 5, for 5 seconds and then, if that works, lower
them, cut and try, to find the proper "balance." You _are_ setting the
permissions of the script to "x" are you not?... Chmod 0755 a good
start if you're logged in as root...

    Hal - in Terra Alta, WV - Slackware GNU/Linux 9.0   (2.4.20)
           
             Anyone can pile complexity upon complexity;
                  only a genius can truly simplify..
.