Baslinux mailing list

["Sheldon Isaac" <sisaac AT netaxs.com>]

On 12 May 2004 at 12:18, Sindi Keesan wrote:
> Is it possible instead to just write and use a script to load the modules 
> with the correct address and irq?  I tried this with plip and could not 
> get the script to work, though typing the five lines manually worked.

Sindi,

It should be possible. I will reboot to BL2.1 and look at module loading.

As I may have said, I most recently have the module for my NIC loaded from 
rc.S, which I think is a script that is executed on startup.

But one would think that modules can be loaded from a script to be run from 
the command line.

Sorry, I haven't been following this closely, and you may be talking about 
BL3?  Should be generally the same regarding syntax, though.

Regards,

Sheldon Isaac