Baslinux mailing list

[baslinux AT lists.ibiblio.org]

Message from Steven
===================
Sindi wrote:
>
> I still had to insmod sb despite it being built in.  
> This is apparently ISA sound and needs the io irq 
> and dma specified.  Is there some way to specify them 
> at boot time with loadlin instead of insmodding the 
> driver after you boot?

----------------------------------
Loadlin parameters for sound cards:
----------------------------------

sound=0x0TTPPPID, ..
                                                                  
     all values are enbedded in one longint, the above format
     shows a hex number, each place is a hex-digit
                                      
TT   Supported card type.
                                                    
     This is the index into the list of configured cards
     If all cards are configured (which normally is not the case)
     the following order is kept:                                            
                                   Roland MPU-401
                                   Gravis Ultrasound
                                   ProAudio Spectrum
                                   SoundBlaster
                                   SoundBlaster 16
                                   SB16 MPU-401 (SB16-MIDI port)
                                   AdLib
                                                           
PPP  Port Address

I    IRQ

D    DMA Channel