Baslinux mailing list

["Sheldon Isaac" <SheldonIsaac AT MyRealBox.com>]

I will reply more later.

Sindi said, in part:

> Please try it also with David's 2.4.31 kernel and modules, posted at 
> http://keesan.freeshell.org/bl/2.4.31 - bzImage.431.gz (gunzip it first) 
> and the modules are in userspec.tgz.431 - remove the '431', unpack it in 
> /tmp, and just copy over the modules: usbcore.o usb-ohci.o and usb-storage 
> to /lib/modules/2.4.31/misc (make that directory and subdirectory).
SNIP
> This kernel has built-in scsi, no need for scsi_mod and sd_mod.
> Hit 'Enter' after you see a line about sda1 to get the prompt back.

I did the above.
And insmodded the 3 modules.

Will type what I see on the "other" computer ( BL2.1) after I plugged in the 
reader with SD card:

hub.c: new USB device 00:02,0-1, assigned address 2

scsi0 : SCSI emulation for USB Mass Storage devices

  Vendor: Generic  Model: STORAGE DEVICE Rev: 0100

  Type:    Direct-Access                   ANSI SCSI revision: 02

Attached scsi removable disk sda at scsi0, channel 0, id 0, lin 0

sda: Write Protect is off

 sda:  sda1
  ==============

It shows up when I say   fdisk /dev/sda

And   mount -t msdos /dev/sda1 /mnt   works fine.


Thanks,
Sheldon