Skip to Content.
Sympa Menu

baslinux - Re: [BL] PCMCIA network and modem ERROR messages

baslinux AT lists.ibiblio.org

Subject: Baslinux mailing list

List archive

Chronological Thread  
  • From: James Miller <jamtat AT mailsnare.net>
  • To: baslinux AT lists.ibiblio.org
  • Subject: Re: [BL] PCMCIA network and modem ERROR messages
  • Date: Fri, 26 Sep 2003 07:54:31 -0500 (CDT)

On Fri, 26 Sep 2003, HenRi KiRya wrote:

> you could send me the attachements for the redhat kernels, will give those a
> try too
> thanks
>
Any message I try to send you is getting blocked by a filtering rule,
HenRi (yours? your ISP's?). If you want me to send this kernel (ca. 650
KB), you'll need to fix that and let me know when it's possible to send.

James

> the actual error message for the rtl is as follows;
>
> init_module: rtl8139 device or resource busy
>
>
> -----Original Message-----
> From: James Miller <jamtat AT mailsnare.net>
> To: baslinux AT lists.ibiblio.org <baslinux AT lists.ibiblio.org>
> Date: Friday, September 26, 2003 6:40 PM
> Subject: Re: [BL] PCMCIA network and modem ERROR messages
>
>
> >On Fri, 26 Sep 2003, HenRi KiRya wrote:
> >>
> >> i have found some driver modules for the card (fethcb_c.o)
> >> one was written for the 2.2.14-5.0 kernel ( redhat 6.2)
> >> the other for 2.2.16-22 ( redhat 7.0)
> >>
> >> i still get kernel version mismatch errors
> >> when i insmod fethcb_c.o -f
> >> unresolved symbol register drive
> >>
> >> is it possible to find where could i fing the above mentioned kernels in
> a
> >> format tht is useable in
> >> baslinux ?
> >> i tried to find one from the redhat site and it was in the .rpm format
> >>
> >I have a hard disk laying around where I believe I still have RH 6.2
> >installed with the stock kernel. I could take a look and perhaps email it
> >to you as an attachment, if that would help. Not sure about where you
> >could find it, or the RH 7.0 kernel on the 'net, though.
> >
> >> and Steven ive tried to insmod the rtl8139.o from slackware 7.1
> >> win no success
> >>
> >Could you say more about what "no success" means? Do you get some error
> >message when you try to insmod this module? If so, what is it? What are
> >any other symptoms that lead you to conclude that you've had "no success"
> >insmod'ing the rtl8139.o module?
> >
> >James
> >_______________________________________________
> >BasLinux mailing list
> >BasLinux AT lists.ibiblio.org
> >http://lists.ibiblio.org/mailman/listinfo/baslinux
>
>
> _______________________________________________
> BasLinux mailing list
> BasLinux AT lists.ibiblio.org
> http://lists.ibiblio.org/mailman/listinfo/baslinux




Archive powered by MHonArc 2.6.24.

Top of Page