Baslinux mailing list

["HenRi KiRya" <henry AT cmf.co.ug>]

you could send me the attachements for the redhat kernels, will give those a
try too
thanks

the actual error message for the rtl is as follows;

init_module: rtl8139 device or resource busy


-----Original Message-----
From: James Miller <jamtat AT mailsnare.net>
To: baslinux AT lists.ibiblio.org <baslinux AT lists.ibiblio.org>
Date: Friday, September 26, 2003 6:40 PM
Subject: Re: [BL] PCMCIA network and modem ERROR messages


>On Fri, 26 Sep 2003, HenRi KiRya wrote:
>>
>> i have found some driver modules for the card (fethcb_c.o)
>> one was written for the 2.2.14-5.0  kernel ( redhat 6.2)
>> the other for 2.2.16-22 ( redhat 7.0)
>>
>> i still get kernel version mismatch errors
>>  when i insmod fethcb_c.o  -f
>> unresolved symbol register drive
>>
>> is it possible to find where could i fing the above mentioned kernels in
a
>> format tht is useable in
>> baslinux ?
>> i tried to find one from the redhat site and it was in the .rpm format
>>
>I have a hard disk laying around where I believe I still have RH 6.2
>installed with the stock kernel.  I could take a look and perhaps email it
>to you as an attachment, if that would help.  Not sure about where you
>could find it, or the RH 7.0 kernel on the 'net, though.
>
>> and Steven ive tried to insmod the rtl8139.o from slackware 7.1
>> win no success
>>
>Could you say more about what "no success" means?  Do you get some error
>message when you try to insmod this module?  If so, what is it?  What are
>any other symptoms that lead you to conclude that you've had "no success"
>insmod'ing the rtl8139.o module?
>
>James
>_______________________________________________
>BasLinux mailing list
>BasLinux AT lists.ibiblio.org
>http://lists.ibiblio.org/mailman/listinfo/baslinux