Skip to Content.
Sympa Menu

baslinux - [BL] USB kernel and CD burning

baslinux AT lists.ibiblio.org

Subject: Baslinux mailing list

List archive

Chronological Thread  
  • From: Christof Lange <cce.zizkov AT volny.cz>
  • To: baslinux AT lists.ibiblio.org
  • Subject: [BL] USB kernel and CD burning
  • Date: Fri, 5 Jan 2007 15:54:49

Hi Sindi,

finally I succeeded to create a clean initrd.gz file and all USB
devices can be mounted with it. So I moved to the other computer
in order to test CD burning.

There, however, I was not even able to mount the CD for reading.
Unfortunately some changes to the file system on the hard
disk, had the effect that even in the SW 7.1 installation the
CD-ROM mounting completely ceased to work.

Burning CDs with the new kernel does not work either. I tried to
make the file system on the RAM disk as similar as possible to the
one on the hard disk partition, and with the 2.2.16 burning still
works. So I am almost sure that the problem is in the l8 kernel.

When I try to run cdrecord with your kernel I get the messages:

Cannot open /dev/pg0

Cannnot open /dev/pg*
Cannot open SCSI driver

Here are the modules which the 2.2.16 kernel needs to burn CD:

insmod ide-cd
#ignore=hdc
insmod scsi_mod
insmod sg
insmod sr_mod
insmod loop
insmod ide-scsi

IIRC 2.2.16 is the bare kernel from Slackware 7.1. Its size is
735763 bytes.

Christof

________________________________________________________________

Ceskobratrska cirkev evangelicka - Betlemska kaple na Zizkove
Prokopova 4/216, 130 00 Praha 3, Czech Republic
Tel. (+420) 222 78 06 73 / 222 78 20 02 / 603 18 87 53
http://www.volny.cz/cce.zizkov





Archive powered by MHonArc 2.6.24.

Top of Page