Baslinux mailing list

[baslinux AT lists.ibiblio.org]

On the subject of D-link cards, I got a DFE-530TX+ and I know what 
module I need for it, but my experience with DSL says that I'll need to 
specify IRQ and IO despite it being a PCI card. I have no clue how to go 
about this, does anyone?
On 01/17/2009 11:48 PM, baslinux AT lists.ibiblio.org wrote:
> On Tue, Jan 13, 2009 at 7:32 PM, <baslinux AT lists.ibiblio.org 
> <mailto:baslinux AT lists.ibiblio.org>> wrote:
>
>     So I got a DE-220PCT for the computer (486, 8MB RAM) that I intend on
>     using BasicLinux with (dualboot with DOS 6.22). It's a 16-bit ISA
>     ethernet/coaxial adapter. I'm just wondering if anyone has had any
>     experience with it and whether or not they know if it works or
>     does not
>     work in BL3.
>
>     -Zach
>
>
> I use the D-Link DE-220P a lot.  As mentioned previously, it uses the 
> NE driver
> and you need to provide the irq & io addresses.  I have used it with BL3.
>
> You will need to disable the PNP mode (if it has been set) and set the 
> irq & io address to known values.  Look for the D-Link DOS program 
> called 'setup.exe' (available at DriverGuide, 
> http://www.network-drivers.com/drivers/16/16607.htm) and use it to set 
> the values and store them on the card.  It also does card diagnostics.
>
> Eric (first-time poster, long-time lurker)
>
>
>
> ------------------------------------------------------------------------
>
>
> -----------------------
> BasicLinux mailing list
> -----------------------
> http://www.basiclinux.com.ru
> http://www.ibiblio.org/pub/linux/distributions/baslinux/
> ------------------------------------
> To exit, send subject=unsubscribe to
> baslinux-request AT lists.ibiblio.org