Baslinux mailing list

[baslinux AT lists.ibiblio.org]

All right, I made /dev/urandom and resolv.conf looks good, so I guess
everything is working great.  Is there anyway to have
/etc/pcmcia/start and udhcpc run when as soon as I boot?

Thanks, you've been a great help.

On Thu, Apr 24, 2008 at 9:02 PM,  <baslinux AT lists.ibiblio.org> wrote:
> >> > Sorry my last post was so rushed, but I should also add that BL is 
> >> > loading
>  >> > all of the same modules as Tomsrbt except for the xirc2ps_cs driver.
>  >>
>  >>  It will NOT load that module if you got it from the Tomsrtbt disk, you
>  >>  need to get the one from the BL site.  They are specific to each kernel
>  >>  version, and also you need to be using a kernel compiled on a similar
>  >>  system (same gcc?).
>  >
>  > Ah, ok.  I downloaded the driver from the BL website and now
>  > everything is working.  udchcpc complains that there is no
>  Glad to hear it.  I think you mentioned in an earlier email that you
>  copied the module from tomsrtbt.
>
>
>  > /dev/urandom, can I just ignore that?
>
>
>  mknod /dev/urandom c 1 9
>
>
>  Check whether udhcpc is rewriting your
>  /etc/resolv.conf
>
>  If you use a modem, this will prevent you from accessing websites and you
>  need to add the correct DNS numbers again.
>
>  > Thanks!
>  Glad I could help.  I asked lots of questions about this over the years.
>
>
>
>  >>  Sindi
>  >>
>
>  -----------------------
>  BasicLinux mailing list
>  -----------------------
>  http://www.basiclinux.com.ru
>  http://www.ibiblio.org/pub/linux/distributions/baslinux/
>  ------------------------------------
>  To exit, send subject=unsubscribe to
>  baslinux-request AT lists.ibiblio.org
>