Baslinux mailing list

[baslinux AT lists.ibiblio.org]

I'm sorry about posting so soon, but I've sorted out my last problem and now have a new problem:

BL won't detect my Xircom IIps PS-CE2-10 network card.  I had it a few minutes ago, but I was forced to install BL and I lost my files (my fault completely, I should have known better).

I copied some files over from Tomsrbt, which detects my network card and connects to the network automatically.  The files were /etc/hosts, /etc/host.conf, /etc/rc.pcmcia, /etc/resolv.conf, /etc/pcmcia/conf, /etc/pcmcia/config.opts, /etc/pcmcia/network, /etc/pcmcia/network.opts, amd /etc/pcmcia/shared (I know not all of those are originaly included in BL, but they were needed by the Tomsrbt files).  Here's the output from /etc/pcmcia/start: (I couldn't get all of it, but this is most of it.  A bit is cut off from the top)

   Vadem VG-469 rev 00 ISA-to-PCMCIA at port 0x3e0 ofs 0x00
        host opts [0]: none
        host opts [1]: none
        ISA irqs (scanned) = 3,4,5,7,9,10,11,15 status change on irq 15
Using /lib/modules/2.2.26/pcmcia/ds.o
Apr 23 16:40:17 cardmgr[35]: starting, version is 3.1.16
Apr 23 16:40:17 cardmgr[35]: watching 2 sockets
Apr 23 16:40:17 cardmgr[35]: Card Services release does not match
Apr 23 16:40:17 cardmgr[35]: initializing socket 1
cs: memory probe 0x0d0000-0x0dffff: clean.
Apr 23 16:40:17 cardmgr[35]: socket 1: Xircom IIps Ethernet
Apr 23 16:40:17 cardmgr[35]: excuting: ' insmod /lib/modules/2.2.26/pcmcia/xirc2ps_cs.o'
xirc2ps_cs.c 1.31 1998/12/09 19:32:55 (dd9jn+kvh)
xirc2ps_cs: Card Services release does not match!
Apr 23 16:40:17 cardmgr[35]: + Using /lib/modules/2.2.26/pcmcia/xirc2ps_cs.o
Apr 23 16:40:17 cardmgr[35]: + insmod: init_modules: xirc2ps_cs: Device or resource busy
Apr 23 16:40:17 cardmgr[35]: insmod exited with status 1
Apr 23 16:40:17 cardmgr[35]: executing: 'modprobe xirc2ps_cs'
Apr 23 16:40:18 cardmgr[35]: get dev info on socket 1 failed: Try again
Apr 23 16:40:18 cardmgr[35]: exiting

Then udhcpc says....

info, udhcpc (v0.9.9-pre) started
error, SIOCGIFINDEX failed!: No such device

Which I assume means that it doesn't see the network card (right?).

Thanks, 
Meyer