market-farming AT lists.ibiblio.org
Subject: Market Farming
List archive
- From: "waldenfarm" <waldenfarm AT bellsouth.net>
- To: "Market Farming" <market-farming AT lists.ibiblio.org>
- Subject: Re: [Market-farming] roll up sides
- Date: Mon, 15 Nov 2010 16:35:05 -0500
If you want a snap on clamp so you don't have to use screws:
Get enough 1" PVC pipe to match the length of your sides & galv. pipe. (PVC gray conduit is UV stabilized & won't get brittle.)
Set up your table saw fence to rip 1/3 of the diameter of the pipe off.
Debur the edges on the 2/3 diameter.
Use this to clamp over the steel pipe with the plastic wrapped around it.
Or you can cut the ripped pipe into 3-4" lengths and space clamps out.
Alex McGregor
Walden Farm
SE TN
----- Original Message ----- From: "Richard Robinson" <rrobinson AT nasw.org>
To: "Market Farming" <market-farming AT lists.ibiblio.org>
Sent: Monday, November 15, 2010 3:44 PM
Subject: Re: [Market-farming] roll up sides
Nolts sells a "roll bar cap" (their ID # GFA5RBC). You use Tec-screws to attach it to the pipe, with the plastic in between. A piece of light-weight aluminum or steel C channel would do the same job, though it wouldn't have the curve in it that the real product has.
--
Richard Robinson
-
[Market-farming] roll up sides,
Ryan Wood-Beauchamp, 11/15/2010
-
Re: [Market-farming] roll up sides,
Richard Robinson, 11/15/2010
- Re: [Market-farming] roll up sides, waldenfarm, 11/15/2010
- Re: [Market-farming] roll up sides, Steve Diver, 11/15/2010
-
Re: [Market-farming] roll up sides,
MAsteveINE, 11/15/2010
- Re: [Market-farming] re rants and photos, Road's End Farm, 11/15/2010
- [Market-farming] Screws, MAsteveINE, 11/15/2010
-
Re: [Market-farming] roll up sides,
Richard Robinson, 11/15/2010
Archive powered by MHonArc 2.6.24.