Skip to Content.
Sympa Menu

market-farming - Re: [Market-farming] allis g - implement lift problems. . .

market-farming AT lists.ibiblio.org

Subject: Market Farming

List archive

Chronological Thread  
  • From: "Franklin W. Davis" <knarfme AT comcast.net>
  • To: "Market Farming" <market-farming AT lists.ibiblio.org>
  • Subject: Re: [Market-farming] allis g - implement lift problems. . .
  • Date: Tue, 5 Feb 2008 16:29:07 -0500 (Eastern Standard Time)

  Hi John...I don't know what year your Allis is...but if it's older then '85 get on Yesterdays Tractors...good source for parts...and some real good forums...Franklin 
 
-------Original Message-------
 
Date: 02/05/08 16:20:09
Subject: [Market-farming] allis g - implement lift problems. . .
 
hello. . . more allis g problems, maybe
 
i've been rehabing a g.  currently getting the belly mount lift in
order, but came across a snag.  measured from the front axle to a
mounted toolbar, i have a .75" difference left and right. . . so the
linkage isn't quite parallel.  there is also a 1" of difference between
the height, left and right.  i've replaced most parts readily available,
including linkage bolts, frame bolts, etc.  the linkage parts match up
well, and i don't think they are the cause.  the linkage bolts, at the
lower rear arms, were previously repaired and failed.  replaced with
bolts and nylocks because i can't find the right sized lugs.
 
anyway. . . i'm concerned with the differences in height and camber (?)
on the implement bars.  If i'm pulling a plant jr seeder or cultivator
it will be sliding sideways.  outside of just being annoying will this
cause any major operational problems?  maybe i'm just being too uptight?
 
btw, the nissan alternator bolted up ok, with a modified mount.  if i
could do it again, i'd use a late 70's or early 80's alternator (used
84+ model year).  the older ones have a voltage rectified that's not
part of the alternator housing and is adjustable.  currently putting out
19 volts once it warms up. thanks for the help from last year.
 
also, does anyone have a good source for parts?  the clutch throwout
bearing sounds a little roasted
 
thanks
john
danville,in
_______________________________________________
Market-farming mailing list
 
 
 
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.516 / Virus Database: 269.19.20/1260 - Release Date: 2/5/2008 9:44 AM
 
.



Archive powered by MHonArc 2.6.24.

Top of Page