Skip to Content.
Sympa Menu

machinist - [machinist] Fwd: [Hardinge-Mill] Re: Oil fittings on bed

machinist@lists.ibiblio.org

Subject: Machinist

List archive

Chronological Thread  
  • From: Lawrence London <lfljvenaura@gmail.com>
  • To: machinist@lists.ibiblio.org
  • Subject: [machinist] Fwd: [Hardinge-Mill] Re: Oil fittings on bed
  • Date: Sat, 9 Jan 2016 16:29:42 -0500


---------- Forwarded message ----------
From: bearbon@comcast.net [Hardinge-Mill] <Hardinge-Mill@yahoogroups.com>
Date: Sat, Jan 9, 2016 at 4:05 PM
Subject: [Hardinge-Mill] Re: Oil fittings on bed
To: Hardinge-Mill@yahoogroups.com


 

Assuming you mean the oil fittings with the little spring loaded ball, you just use a pump type oil can with a rounded tip. Just push the ball in with the nozzle of the oil can and pump. Make sure the rounded tip of the nozzle seals around the oil hole. There are also grease gun tips that are similar if you want to use grease instead of oil.

__._,_.___

Posted by: bearbon@comcast.net
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (2)

.

__,_._,___



--


  • [machinist] Fwd: [Hardinge-Mill] Re: Oil fittings on bed, Lawrence London, 01/09/2016

Archive powered by MHonArc 2.6.24.

Top of Page