[permaculture] small cooking woodstove

Scott Vlaun scott at moosepondarts.com
Sun Oct 7 09:56:22 EDT 2007


Lawrence,

What I actually have is a 9x3 stone and mortar wall on top of a  
larger concrete footing. The wall forms part of the foundation. I  
could cantilever a slab out from it to gain a little more footprint  
if needed. Our plan is for a fire box and serpentine flu than is all  
on the same plane with a small oven and bench with a fieldstone  
veneer. I've seen such compact units but have no details.


Scott Vlaun
Moose Pond Arts+Ecology
Design Solutions for a Sustainable Future

450 Main St. Studio 2
Norway, Maine 04268
207-739-2409 Studio
207-890-4099 Cell
http://www.moosepondarts.com



On Oct 6, 2007, at 6:55 PM, Lawrence F. London, Jr. wrote:

> Scott Vlaun wrote:
>
>> We have a footing under our kitchen for a masonry
>> furnace with a small oven, but no time or funds to complete it at
>> this point. If anyone has good plans for such a heater that will fit
>> on a 9x3 ft footing I'd love to hear about them.
>
> How would you be able to locate a masonry woodburning stove with  
> chimney on
> a slab 9' X 3'? With an appropriate flue liner, or masonry stove  
> equivalent,
> you would automatically be up to a minimum of 4' width most  
> probably, IOW too narrow
> for what you want to build. Given that it will extend through one  
> full floor plus attic, add more for
> clearance above ridge of roof, a lot of weight will be involved.  
> Does your 9X3 include a footing around the perimeter?
> If not, you'll need this feature for loadbearing strength. This  
> will be a grade beam or monolithic slab. If you need to
> extend the dimensions and thickness of your slab or add footings  
> you can use a hammerdrill with 5/8 or 7/8 masonry bit
> to make horizontal holes around the permieter of the slab or  
> anywhere else you need to connect the old slab to new
> concrete added to increase dimensions. Cut short lengths of 1/2" or  
> 3/4" rebar to put in these holes with enough length
> to extend well into the new area to be poured. Add heavy gauge  
> concrete reinforcing wire mesh and plenty ot rebar
> adequately tied. Use 6000 psi concrete with fiber reinforcing. Be  
> sure to prepare the new footings by digging under the
> edge of the existing slab so new concrete will go under it for  
> added weight bearing capacity; the rebar pins should add
> strength to this by preventing settling.
>
> -- 
> Lawrence F. London, Jr.
> lflj at intrex.net
> Venaura Farm http://venaurafarm.blogspot.com
> Agriculture, Market Farming & Permaculture
> http://www.ibiblio.org/ecolandtech
>
> _______________________________________________
> permaculture mailing list
> permaculture at lists.ibiblio.org
> Subscribe or unsubscribe here:
> http://lists.ibiblio.org/mailman/listinfo/permaculture
>
>
>




More information about the permaculture mailing list